Home & GardenProcessed in your browser

Cabinet Hardware Placement Calculator

Calculate drill-hole marks for knobs and pulls on upper and base doors

How to use Cabinet Hardware Placement Calculator

  1. Step 1: Select cabinet & hardware type - Cabinet Hardware Placement Calculator
    Step 1

    Select cabinet & hardware type

    Choose upper or base cabinet, and pick knob or pull.

  2. Step 2: Enter door dimensions & style - Cabinet Hardware Placement Calculator
    Step 2

    Enter door dimensions & style

    Enter width, height, and stile width for shaker doors.

  3. Step 3: Read hole marks - Cabinet Hardware Placement Calculator
    Step 3

    Read hole marks

    Follow the exact X and Y coordinates to mark your drilling template.

About this tool

The Cabinet Hardware Placement Calculator provides accurate, proportional drilling coordinates for cabinet door knobs, handles, and pulls. Supporting upper wall cabinets, base cabinets, tall utility cabinets, and drawer fronts, this utility takes the guesswork out of kitchen and bathroom hardware installation.

Whether installing on classic shaker stiles or contemporary flat slab doors, the calculator accounts for frame stile widths, conventional 2" to 3" corner offset guidelines (recommended by the National Kitchen and Bath Association and leading hardware manufacturers like Emtek), and standard center-to-center pull screw spacings (from 3" up to 12" appliance pulls).

An interactive SVG diagram visualizes hole positions relative to the opening edge opposite hinges, preventing costly misdrills on finished wood or painted cabinetry. All calculations execute directly in your web browser with zero server uploads.

Read the full guide

Cabinet Hardware Placement Guide (Knobs & Pulls)

Key Features

  • Visual interactive diagram with proportional door dimensions
  • Supports upper wall cabinets, base cabinets, and tall pantries
  • Shaker stile centering and slab door offset presets
  • Standard pull sizes (3", 96mm, 128mm, 160mm, 192mm)
  • Blowout prevention and drill guide checklist

Limitations

  • •Placement measurements represent conventional guidelines. Verify interior shelf clearance before drilling.
  • •Specialty curved, glass, or European inset doors may require adjusted hinge setbacks.

Tips & common mistakes

  • •Clamp a scrap wood backer block tightly to the backside of the cabinet door before drilling to eliminate wood blowout.
  • •Always use a sharp 3/16" brad point drill bit held strictly perpendicular to the cabinet face.
  • •Make a reusable cardboard or scrap wood jig after drilling your first door to ensure consistent placement across all cabinets.

Last updated:

Cabinet Hardware Placement Calculator FAQ

Conventionally, upper door knobs are placed 2.5 inches from the bottom corner opposite the hinges. On shaker doors, the knob is centered horizontally on the vertical stile.
Base cabinet pulls are placed 2.5 to 3 inches from the top corner opposite the hinges so you do not have to bend down too low to open the cabinet.

Related tools

More tools from the same category and nearby utilities.