Home & GardenProcessed in your browser

Fence Picket Calculator

Calculate exact picket counts, posts, 2x4 rails & deck screws for privacy & picket fences

How to use Fence Picket Calculator

  1. Step 1: Enter fence run length - Fence Picket Calculator
    Step 1

    Enter fence run length

    Input the total length of your planned fence run in linear feet.

  2. Step 2: Select picket size and gap - Fence Picket Calculator
    Step 2

    Select picket size and gap

    Choose 1x6 (5.5" actual) or 1x4 (3.5" actual) and set your desired gap spacing.

  3. Step 3: Choose height and waste - Fence Picket Calculator
    Step 3

    Choose height and waste

    Pick 4ft, 6ft, or 8ft height and add a 10% lumber waste allowance.

  4. Step 4: Copy materials list - Fence Picket Calculator
    Step 4

    Copy materials list

    Review the bill of materials for pickets, 4x4 posts, 2x4 rails, and exterior screws.

About this tool

The Fence Picket Calculator determines the precise bill of materials required to build a wood fence. Whether you are assembling a closed privacy fence (butt joints) or a spaced decorative picket fence, this tool eliminates guesswork.

Lumber sizing is one of the leading causes of ordering errors: standard 1x6 fence pickets actually measure 5.5 inches wide, and 1x4 pickets measure 3.5 inches. Failing to account for actual milled widths leaves projects short by up to 10% on lumber. This calculator uses actual dimensions, accounts for post spacing (typically 8 feet on center), and calculates the required line, end, and corner posts, horizontal 2x4 rails (2 rails for 4 ft, 3 rails for 6 ft), and exterior construction fasteners.

Read the full guide

Fence Picket Sizing, Spacing, and Post Layout Guide

Key Features

  • Actual milled lumber dimensions for 1x4 (3.5") and 1x6 (5.5") boards
  • Custom gap width support from 0" (full privacy) up to 3" spaced pickets
  • Automatic post and horizontal 2x4 rail sizing based on fence height (4ft vs 6ft)
  • Exterior deck screw estimation per rail intersection
  • Interactive SVG fence visualization and printable cut sheet

Tips & common mistakes

  • •Keep pickets 1 to 2 inches above ground line to avoid moisture wicking and rot.
  • •Use 3 horizontal 2x4 rails for 6-foot fences to prevent warping.
  • •Always use exterior-rated or stainless steel deck screws instead of interior nails.

Last updated:

Fence Picket Calculator FAQ

A nominal 1x6 cedar or pressure-treated fence picket has an actual milled width of 5.5 inches (140 mm). Always calculate picket counts using 5.5 inches rather than 6 inches.
Standard residential wood fence posts are spaced 8 feet (96 inches) on-center. In high-wind areas or for heavy shadowbox fences, 6-foot spacing is recommended.
A 6-foot privacy fence requires 3 horizontal 2x4 rails per 8-foot bay (top, middle, and bottom) to prevent picket bowing and warping. Fences 4 feet or shorter typically require only 2 rails.
A 10% waste allowance is recommended for wood fence boards to account for natural warping, cupping, knots, and edge trimming.

Related tools

More tools from the same category and nearby utilities.