How to use Drawer Pull Placement Calculator
- Step 1
Enter drawer dimensions
Enter total drawer front width and height in inches.
- Step 2
Select 1 or 2 pulls
Choose single pull for standard drawers or 2 pulls for wide drawers.
- Step 3
Pick pull C2C spacing
Select the center-to-center distance between screws on your hardware.
About this tool
The Drawer Pull Placement Calculator determines exact hole coordinates for mounting single or dual handles on kitchen and furniture drawer fronts. Whether working with narrow silverware drawers or heavy 36-inch pot-and-pan drawers, this tool eliminates measuring mistakes before drilling through finished cabinetry.
The calculation engine supports both visual center (dead-center of the drawer face) and traditional upper-third placement (often preferred on deep bottom drawers to balance visual weight against drawer pulls above). For drawers 24 inches or wider, it automatically computes dual-pull positions using the balanced rule of fourths, ensuring pulls are placed symmetrically at 1/4 and 3/4 of the drawer width.
Everything runs client-side in your web browser with copyable drill marks and an interactive layout diagram.
Read the full guide
How to Center and Space Drawer Pulls
Key Features
- Single centered pull and dual pull spacing modes
- Dead-center vs. traditional upper-third vertical alignment
- Supports all standard metric and imperial pull lengths
- Calculates exact X and Y drill coordinates from edges
- Visual drawer front diagram with hole crosshairs
Limitations
- •Calculations assume rectangular drawer fronts. Custom routed profiles may require adjusted vertical offsets.
Tips & common mistakes
- •Drawers 24" or wider typically benefit from two pulls or an extra-long appliance pull (8" to 12") to avoid drawer racking.
- •Check interior drawer box clearance: some drawer fronts sit on a sub-box that requires longer screws (1.5" or 1.75").
- •Use blue painter's tape across the front of the drawer, mark your drill centers on the tape, and double check with a ruler.
Last updated: